Advanced Screen - ZyXEL Communications LTE5366 Series User Manual

Table 64 Configuration > Management > Bandwidth Management > General (continued)
LABEL
Flexible Bandwidth
Management
Cancel
Apply

21.5 Advanced Screen

Use this screen to configure bandwidth management rules for the pre-defined services or applications.
You can also use this screen to configure bandwidth management rule for other services or applications
that are not on the pre-defined list of LTE5366. Additionally, you can define the IP addresses and port for
a service or application.
Click Management > Bandwidth MGMT > Advanced to open the bandwidth management Advanced
screen.
Figure 94 Management > Bandwidth Management > Advanced
The following table describes the labels in this screen.
Table 65 Management > Bandwidth Management > Advanced
LABEL
Add New Rule
Rule Lists
#
Status
Grouping
Service
Control
Direction
Chapter 21 Bandwidth Management
DESCRIPTION
Select Enable to use up to 100% of the configured bandwidth. If you select Disable, you can
only use up to 33% of the configured bandwidth.
Click Cancel to begin configuring this screen afresh.
Click Apply to save your customized settings.
DESCRIPTION
Click this to open a screen where you can create a new bandwidth management rule for a
service or application.
This is the number of an individual bandwidth management rule.
This field indicates whether the rule is active (yellow bulb) or not (gray bulb).
This field displays the IP address or a range of IP addresses of the destination computer for
whom this rule applies.
This field displays the protocol and port used for the service.
This field displays whether the maximum/minimum bandwidth allowed or a priority level is
specified in the rule.
These read-only labels represent the physical interfaces. Bandwidth management applies to
all traffic flowing out of the router through the interface, regardless of the traffic's source.
LTE5366 Series User's Guide
148