What You Need To Know; General Screen - ZyXEL Communications LTE5366 Series User Manual

21.3 What You Need To Know

The sum of the bandwidth allotments that apply to the WAN interface (LAN to WAN, WLAN to WAN)
must be less than or equal to the upstream bandwidth that you configure in the Bandwidth
Management > General screen
The sum of the bandwidth allotments that apply to the LAN interface (WAN to LAN, WAN to WLAN) must
be less than or equal to the downstream bandwidth that you configure in the Bandwidth Management
> General screen

21.4 General Screen

Use this screen to have the LTE5366 apply bandwidth management.
Click Configuration > Management > Bandwidth MGMT to open the bandwidth management General
screen.
Figure 93 Configuration > Management > Bandwidth Management > General
The following table describes the labels in this screen.
Table 64 Configuration > Management > Bandwidth Management > General
LABEL
Bandwidth
Management
Bandwidth of
Upstream
Bandwidth of
Downstream
Chapter 21 Bandwidth Management
(Section 21.5 on page
(Section 21.5 on page 148).
DESCRIPTION
This field allows you to have LTE5366 apply bandwidth management.
Enable bandwidth management to give traffic that matches a bandwidth rule priority over
traffic that does not match a bandwidth rule.
Enabling bandwidth management also allows you to control the maximum or minimum
amounts of bandwidth that can be used by traffic that matches a bandwidth rule.
Specify the total amount of bandwidth that you want to dedicate to uplink traffic. The
recommendation is to set this to match the actual upstream data rate.
This is traffic from LAN/WLAN to WAN.
Specify the total amount of bandwidth that you want to dedicate to downlink traffic. The
recommendation is to set this to match the actual downstream data rate.
This is traffic from WAN to LAN/WLAN.
LTE5366 Series User's Guide
148).
147