User's Dip Sw Setting - Roland Color Camm Pro PC-60 Service Notes

7 Supplement

7-2 USER'S DIP SW SETTING

Following table describes the settings of the DIP SW located at the right side of the machine.
Bit#9 and bit#10 are not announced to the end users.
RIBBON ECONOMY MODE
Ribbon Economy Mode is explained by explaining the way of printing CYAN part of the following figure.
7
Normally, HEAD will be in DOWN position and the RIBBON will be winded from the beginning to the end of 1
BAND.
When selecting Ribbon Economy Mode, CYAN RIBBON won't be winded at the right margin of MAGENTA part,
and the HEAD will be DOWN only at the CYAN part for printing. However, ribbon will be winded at the left part of
MAGENTA part.
MAGENTA
HEAD is down and RIBBON is winded all the time.
ROLAND DG CORPORATION does not guarantee the quality of the printing using the Ribbon
Economy Mode.
The starting point of the printing could be shifted in each BAND.
94
DIP SW Function
SW-1 RS-232C Baud rate
SW-2 RS-232C Parity
SW-3 RS-232 Parity
SW-4 RS-232C Handshake
SW-5 RS-422 Baud rate
SW-6 Front edge sense
SW-7 Blade offset
SW-8 Prefeed mode
SW-9 Ribbon economy mode
SW-10 Auto Power Off function
CYAN
NORMAL MODE
OFF ON
9600 19200
Disable Enable
ODD EVEN
Hardwire XON/XOFF
57.6K 115.2K
Disable Enable
0.25 mm 0.5 mm
Enable Disable
Normal Ribbon economy
Enable Disable
Ribbon can be saved.
CYAN
MAGENTA
HEAD is down and RIBBON is
winded only at CYAN part.
ECONOMY MODE