Service Mode - Roland Color Camm Pro PC-60 Service Notes

4 Adjustment

4-2 Service Mode

[ENTERING]
Turn on the SUB POWER SW while pressing [
[SELECTION]
Each check can be selected by pushing the keys related to them as shown in the table below.
Once you select any check, other checks can not be selected unless you push [SHEET TYPE] key once.
Turn off the SUB POWER SW to finish the SERVICE MODE.
CHECK KEY
4
DRAM [BASE POINT]
EEROM [
PANEL KEY [
DIP SW [
SENSOR [CUT TEST]
40
Write/Verify Test of DRAM.
] Write/Verify Test of EEROM.
] Push the keys in order from the top key to the bottom key.
Turn off all the DIP SW. Turn on the DIP SW in order from bit#1 to
]
bit#10.
This mode is to check the SENSORS and FAN. Following LED will light when sensor is ON.
FRONT PAPER SENSOR : [PIECE] LED
REAR PAPER SENSOR : [ROLL] LED
FRONT COVER SENSOR : [FRONT COVER] LED
PINCH ROLLER SENSOR : [CARTRIDGE HOLDER 1] LED
LIMIT SENSOR : [CARTRIDGE HOLDER 2] LED
SHEET LOAD SENSOR : [CARTRIDGE HOLDER 3] LED
GRIT HOME POSITION SENSOR : [CARTRIDGE HOLDER 4] LED
RIBBON END SENSOR : [CARTRIDGE HOLDER 5] LED
RIBBON CARRIAGE 1 SENSOR : [CARTRIDGE HOLDER 6] LED
RIBBON CARRIAGE 2 SENSOR : [COLOR] LED
FAN ON/OFF : It can be selected by pushing [CUT TEST] key.
], [ ] and [ ] keys to enter the Service Mode.
FUNCTION OK N G
[PIECE] LED : ON [PIECE] LED : BLINK
[ROLL] LED : ON [ROLL] LED : BLINK
[PIECE] LED : ON [PIECE] LED : BLINK
[ROLL] LED : ON [ROLL] LED : BLINK
[PIECE] LED : ON [PIECE] LED : BLINK
[ROLL] LED : ON [ROLL] LED : BLINK
[PIECE] LED : ON [PIECE] LED : BLINK
[ROLL] LED : ON [ROLL] LED : BLINK