Tool Pressure Adjustment - Roland Color Camm Pro PC-60 Service Notes

4 Adjustment

4-7 TOOL PRESSURE ADJUSTMENT

TOOL PRESSURE ADJUSTMENT is for adjusting the voltage supplied to the solenoid of the TOOL
CARRIAGE to ensure that correct pressure would be added to the blade when cutting.
This adjustment must be performed after replacement of the TOOL CARRIAGE, BED and GUIDE RAIL.
It is necessary to enter TOOL PRESSURE ADJUSTMENT MODE in the FACTORY MODE to perform
this adjustment.
ROLAND SPECIAL TOOL ST-002, ST-006 and ST-012 is used for this adjustment.
[TOOL PRESSURE ADJUSTMENT MODE FLOW CHART (in Factory Mode)]
4
After all [CARTRIDGE HOLDER] LED
become ON, it will be turned OFF from 1 to 6 in order.
Then, [PIECE] and [ROLL] LED will be ON.
Save Settings
Make sure to adjsut the TOOL HEIGHT before this
1
adjustment.
Remove the RAIL COVER and put the WHITE DUMMY
PEN (ST-006) to the TOOL CARRIAGE.
48
[ ] or [
[SHEET TYPE] key
Adjust Tool Pressure
[ ] or [
TOOL PRESSURE ADJUSTMENT MODE
MAX. MODE
] key
[BASE POINT] key
] key
MIN. MODE
ST-006
All [CARTRIDGE HOLDER] LED
will be ON.
[CUT TEST] key
Move Tool DOWN
[CUT TEST] key
All [CARTRIDGE HOLDER] LED
will be OFF.
CARRIAGE ASSEMBLY