Manual Thermal Head Density Adjustment - Roland Color Camm Pro PC-60 Service Notes

4-10 MANUAL THERMAL HEAD DENSITY ADJUSTMENT

The purpose of this adjustment is same as for AUTO ADJUSTMENT.
This adjustment should be performed in case of not having the data file for the HEAD or special program
for sending this data automatically.
All 30 parameters can be set manually through the panel. Parameters for the HEAD being used is
mentioned on top of the RAIL.
[THERMAL HEAD DENSITY ADJUSTMENTMODE FLOW CHART (in Factory Mode)]
Send data from PC.
[SHEET TYPE] key
Reset parameters
RESET MODE
to default.
[CARTRIDGE HOLDER 1, 3 & 5] and
[CARTRIDGE HOLDER 2, 4 & 6] will
blink alternately.
SETTING MODE
Change parameters
for HEAD DENSITY.
Save Settings.
Turn on the MAIN POWER SW while pressing [POWER],
1
[SHEET TYPE] and [BASE POINT] keys and enter the
FACTORY MODE.
Select [CARTRIDGE HOLDER 5] with [
and press [SHEET TYPE] key to enter the THERMAL
HEAD DENSITY ADJUSTMENT MODE.
THERMAL HEAD DENSITY
ADJUSTMENT MODE
[CUT TEST] key
[COLOR] LED will be ON.
AUTO. ADJUSTMENT
MODE
[ ] key MANUAL
ADJUSTMENT
[BASE POINT] LED will
be OFF.
[BASE POINT] key
SELECTION
[ ] or [ ] keys
Select GROUP to
be adjusted.
[SHEET TYPE] key
] or [ ] keys
[POWER] key
STITCHING
ADJUSTMENT
[POWER] & [FRONT COVER] LED
MODE
will blink.
[CUT TEST] key
STITCHING ADJUSTMENT
for TOP EDGE.
MODE
[BASE POINT] key [ ] or [ ] keys
[BASE POINT] LED will
be ON.
GROUP
Change parameters for TOP
STITCHING ADJUSTMENT.
MODE
[SHEET TYPE] key
[ ] or [ ] keys
Save Settings.
4 Adjustment
[POWER] & [BASE POINT] LED
will blink.
[ ] key
STITCHING ADJUSTMENT
for BOTTOM EDGE.
[ ] key
[
Change parameters for BOTTOM
STITCHING ADJUSTMENT.
[SHEET TYPE] key
Save Settings.
After all [CARTRIDGE HOLDER] LED
become ON, it will be turned OFF from 1 to 6 in order.
Then, [PIECE] and [ROLL] LED will be ON.
To enter
For selection
4
] or [ ] keys
57