Factory Mode - Roland Color Camm Pro PC-60 Service Notes

4-3 Factory Mode

[ENTERING]
Turn on the MAIN POWER SW while pressing [POWER], [SHEET TYPE] and [BASE POINT] keys to enter the
Factory Mode.
[SELECTION]
Each mode can be entered by selecting the related LED with [
Turn off the MAIN POWER SW to finish the FACTORY MODE.
[CARTRIDGE HOLDER NO.1]
[CARTRIDGE HOLDER NO.2]
[CARTRIDGE HOLDER NO.3]
[CARTRIDGE HOLDER NO.4]
[CARTRIDGE HOLDER NO.5]
[CARTRIDGE HOLDER NO.6]
EEROM INITIALIZE
All data inside the EEROM will
be initialized. Enter the FACTORY
MODE and select EEROM INITIALIZE.
Push [BASE POINT] & [SHEET TYPE] key.
[PIECE] & [ROLL]
LED WILL BLINK
NG
LED
[PIECE] EEROM INITIALIZE
[ROLL] PRINTED LENGTH INITIALIZE
PRINT/CUT OFFSET ADJUSTMENT
TOOL PRESSURE ADJUSTMENT
GRIT COMPENSATION
GRIT ECCENTRICITY ADJUSTMENT
THERMAL HEAD DENSITY ADJUSTMENT
CARTRIDGE POSITION ADJUSTMENT
[PIECE] & [ROLL]
LED WILL BE ON
OK
] and [ ] keys and pressing [SHEET TYPE] key.
MODE
PRINTED LENGTH INITIALIZE
Printed length and cleaning counts will be set to 0.
Enter the FACTORYMODE and
selet PRINTED LENGTH INITIALIZE.
Push [SHEET TYPE] key.
[PIECE] & [ROLL]
LED WILL BLINK
NG
4 Adjustment
4
[PIECE] & [ROLL]
LED WILL BE ON
OK
41