Step 5: Cleaning Of The Periphery Of The Print Heads (Manual Cleaning) - Roland VersaSTUDIO BN-20 Switching Manual

Switching the Ink

STEP 5: Cleaning of the Periphery of the Print Heads (Manual Cleaning)

Important notes on this procedure
 Before attempting this operation, remove any media.
 To prevent the print heads from drying out, finish this procedure in 30 minutes or less. A warning beep sounds after
30 minutes.
 Never use any implements other than the included cleaning sticks. Cotton swabs or other lint-producing items may dam-
age the print heads. If you use up the cleaning sticks, purchase new ones from your authorized Roland DG Corp. dealer.
 Use one cleaning stick per cleaning session, and then discard the stick after use. Reusing cleaning sticks may reduce
the printing quality.
 Do not put a cleaning stick that has been used for cleaning into the cleaning liquid. Doing so will deteriorate the
cleaning liquid.
 Never rub the nozzle surface of the print heads.
 Stroke the sponges very gently, applying as little pressure as possible. Never rub, scrape, or crush them.
CAUTION
Procedure


12
ECO-SOL MAX 3 Ink Switching Method
Be sure to perform operations as specified by the instructions, and never touch any
area not specified in the instructions.
Failure to observe these instructions may cause the machine to move suddenly, resulting
in injury.
Put on the pair of gloves (included).
Follow the on-screen instructions to clean
the area around the print heads.
Thoroughly read the explanation on the screen, and
then perform the cleaning carefully. When you have
finished cleaning the indicated area, click [Next] to
proceed to the next procedure.
During cleaning, use the cleaning liquid that you have
been using since before switching the ink. Use the
cleaning liquid included with the switching kit only
after you have switched the ink.
When the screen shown on the left is displayed,
the cleaning of the area around the print heads is
finished. Proceed to the next procedure.