Figure 4-40 Gad 29/29B Mounting Hardware; Figure 4-41 Gad 29B Inline Transformer Mounting Instructions - Garmin G5 Installation Manual

Figure 4-40 GAD 29/29B Mounting Hardware

4.1.3.1 GAD 29B Transformer Mounting Instructions
For GAD 29B installations interfacing with certain Century and Cessna autopilots an inline
transformer may be required. Refer to Section 5.12 for further information on specific
autopilots.
Solder transformer leads to the appropriate wire per SAE AS4461, and cover with heat shrink
that extends the entire lead of the transformer and at least 0.5 inch of the insulated wire. Do this
for each transformer lead and then cover the entire assembly with heat shrink, extending at least
1 inch past the solder connections.
This assembly must then be secured to the existing aircraft wiring harness near the GAD 29B to
reduce strain on the components. Secure using a minimum of two cable ties, one over the body
of the transformer and one near the solder joints.

Figure 4-41 GAD 29B Inline Transformer Mounting Instructions

Garmin G5 Electronic Flight Instrument Part 23 AML STC Installation Manual 190-01112-10
Rev. 9
Page 62