Garmin G5 Installation Manual page 71

5. Strip the signal wires approximately 0.17 inches.
6. Crimp socket contacts (2) on to the signal wires.
7. Crimp ring terminals (4) on to the shield drain wires.
8. Repeat steps 1 through 7 as needed for the remaining shielded wires.
9. Insert the signal wire socket contacts into the appropriate locations in the D-sub
connector (5).
10. Attach the shield drain ring terminals to the connector backshell shield block using the
supplied screws and washers (11)(12)(13).
11. Wrap the wiring harness with silicone fusion tape (3) at the point where the strain relief
clamp (7) and connector backshell (6) will contact the wiring harness.
12. Attach the strain relief clamp (7) to the connector backshell (6) using the supplied
screws (8).
CAUTION
Placing the concave side of the strain relief clamp across the wiring harness will
damage the wiring harness.
NOTE
Only two ring terminals should be attached to each screw on the connector backshell
shield ground. It is preferred that only two wires be terminated in each ring terminal.
This will necessitate the use of a ring terminal, #8, insulated, 14-16 AWG (MS25036-
153). If only a single wire is left or if only a single wire is needed for this connector a
ring terminal, #8, insulated, 18-22 AWG (MS25036-149) can be used. If more wires
exist for the connector than two per ring terminal, it is permissible to terminate three
wires per ring terminal.
13. Install the connector backshell cover (9) using the supplied screws (10).
Garmin G5 Electronic Flight Instrument Part 23 AML STC Installation Manual
This area intentionally blank
Page 71
190-01112-10
Rev. 9