Garmin G5 Installation Manual page 95

Config Page
Flight Controls
Backlight
Display
Battery
GPS
Navigation
Note: Only used if a third party
autopilot is configured.
If a third party autopilot interface is
configured ON, this configuration
page is set to ENABLED by default.
Units
RS-232
ARINC 429
Exit Configuration Mode
5.5.2 GTN 6XX/7XX Configuration
Config Page
RS-232
Garmin G5 Electronic Flight Instrument Part 23 AML STC Installation Manual
Config Option
Autopilot Servos
Current Mode
Default Mode
Minimum Photocell Input
Minimum Display Brightness
Maximum Photocell Input
Maximum Display Brightness
Filter Time Constant
HSI Page
Power Up Page
Show Battery Status
Automatic Power Off
Internal GPS Receiver
Show Data Fields
Note: This configuration item is only
present when RS-232 Input Format is
configured for MapMx
Navigation Data
Altitude
Distance
Airspeed
Ground Speed
Ground Track
Vertical Speed
Pressure
Data Field Units Display
Input Format
Output Format
Output 1
Output 2
Input 1
Input 2
Input 3
Input 4
Config Option
RS-232 (x)
(x represents any available RS-232
Port )
Page 95
Configuration Setting
None
or
See Section 5.12 if a Third Party Autopilot is
interfaced
Automatic
Automatic
Default
Default
Default
Default
Default
Disabled
PFD
When Using Battery
On Ground Only
Disabled
Show
Enabled
(1)(2)
(1)(2)
(1)(2)(3)
(1)(2)
Magnetic
(1)(2)
(1)(2)
Alternate
MapMx (WAAS Units)
AVIATION (Non WAAS Units)
None
None
None
None
None
None
None
Configuration Setting
Output = MapMX Format 2
190-01112-10
Rev. 9