Garmin G5 Installation Manual page 117

Config Page
Flight Controls
Backlight
Display
Battery
GPS
Navigation
Note: This configuration Page is only
present when RS-232 Input Format is
configured for MapMX
Note: If a third party autopilot
interface is configured ON, this
configuration page is set to ENABLED
by default.
Units
RS-232
ARINC 429
Exit Configuration Mode
Garmin G5 Electronic Flight Instrument Part 23 AML STC Installation Manual
Config Option
Autopilot Servos
Current Mode
Default Mode
Minimum Photocell Input
Minimum Display Brightness
Maximum Photocell Input
Maximum Display Brightness
Filter Time Constant
HSI Page
Power Up Page
Show Battery Status
Automatic Power Off
Internal GPS Receiver
GPS Data Fields
Note: This configuration Item is only
present when RS-232 Input Format is
configured for MapMX
Navigation Data
Altitude
Distance
Airspeed
Ground Speed
Ground Track
Vertical Speed
Pressure
Data Field Display
Input Format
Output Format
Output 1
Output 2
Input 1
Input 2
Input 3
Input 4
Page 117
Configuration Setting
None
or
See Section 5.12 if a Third Party Autopilot is
interfaced
Automatic
Automatic
Default
Default
Default
Default
Default
Disabled
PFD
When Using Battery
On Ground Only
Disabled
Show
Enabled
(1)(2)
(1)(2)
(1)(2)(3)
(1)(2)
Magnetic
(1)(2)
(1)(2)
Alternate
MapMx (WAAS Units)
AVIATION (Non WAAS Units)
None
EFIS / AIRDATA 1 (SDI 1)
(Only used with GTN 6XX / 7XX and GNS
4XX(W) / 5XX(W) and no Third Party Autopilot
is interfaced)
EFIS / AIRDATA 2 (SDI 1)
(Always used with GNS 480 and GTN 6XX /
7XX and GNS 4XX(W) / 5XX(W) when Third
Party Autopilot is interfaced)
None
Garmin GPS (SDI 1)
Garmin VOR/ILS (SDI 1)
None
None
190-01112-10
Rev. 9