Tv Antenna; Lubricating The Elevating Gear; Lubricating The Bearing Surface; Lubricating The Rubber Quad Ring - Jayco COVE 2002 Owner's Manual

TV ANTENNA

Lubricating the Elevating Gear

The elevating gear (Fig. 7-1) will need to be lubricated with a liberal
amount of silicone spray. To lubricate, apply the silicone to the
elevating gear with the lift in the down position then run the lift up and
down a few times to distribute the lubricant over the gears.

Lubricating the Bearing Surface

Twice per year or when rotation of the antenna becomes
difficult, lubricate the bearing surface (Fig. 7-2) between the
rotating gear housing and the base plate with silicone spray.
Elevate the antenna and remove the set screw or plastic plug
from the rotating gear housing. Spray the silicone into the hole
and around the edges of the gear housing. Rotate the gear
housing until the lubricant coats the bearing surface and the
antenna rotates freely.

Lubricating the Rubber Quad Ring

Lubricate the rubber quad ring (Fig. 7-3) located on the elevating shaft below
the worm gear with silicone spray at least twice per year to prevent the quad
ring from becoming brittle resulting in leaks in the elevating shaft. Refer to
the vendor's owner's manual for information regarding removal of the worm
gear assembly.

TOILETS

Aqua Magic® 4
The Aqua Magic 4 does not require routine maintenance except for cleaning. In some installations
the seat and cover can be removed to facilitate cleaning. To remove seat, both seat and cover should
be in the open (up) position. Grasp assembly on both sides and pull away from you in an upward
angle of approximately 45°. To reinstall seat and cover, place legs of assembly in rear slots of cover
until they are centered on hinge posts and gently push down at approximately 45° until you feel the
engagement.

Residential Style

The residential toilet should be maintained as you would for a household toilet. Refer to instructions
supplied with your trailer.
Maintenance/Storage
Fig. 7-1
Lubricate Here
Fig. 7-2
Spray
Remove Plastic
Around
Plug and spray
Edges
lubricant into hole
Fig. 7-3
Wave
Washer
Flat
Washer
Rubber
Ring
83