Manual; Extending Room - Jayco COVE 2002 Owner's Manual

I
WARNING: When the slideout motor brake is released the slideout will not lock into
place, and therefore it will not be sealed from the outdoors! When the slideout has
been retracted, return the brake release lever to its downward position in order to seal
and lock the slideout. Install the transit bars.

Manual

EXTENDING ROOM

#
CAUTION: Additional support jacks are not needed under the slideout. Damage can occur
to your slideout room from improper use of support jacks.
1. Remove the "transit bars" (Fig. 3-11 & 3-12) from behind the top facia board located above
slideout room.
2. Located behind the fender skirt or radius skirt is the slideout lock.
3. To disengage the lock, turn it counter clockwise to
the unlock position. (Fig. 3-16)
4. Insert the crank handle. (Fig. 3-14) Turn the handle
counter-clockwise until slight tension is felt on the
handle.
5. Engage the lock by turning the handle clockwise to
the lock position. (Fig. 3-15)
6. For the bedroom slideout, lift the end of the mattress
and unfold the end of the ply wood on the bed base
at the hinge. (Fig. 3-13)
Fig. 3-14
12
Spring Tension Transit
Bar with Handle
Fig. 3-11
Manual Adjusted
Transit Bar
Fig. 3-12
Fig. 3-15
Fig. 3-13
Fig. 3-16
Cove Owner's Manual