Loading Suggestions - Jayco COVE 2002 Owner's Manual

For portable use:
• Set the temperature selector to Warm/Warm or Warm/Cold (depending on your model).
• To select a different wash or rinse water temperature, adjust the faucet prior to the wash
or rinse water fill.
• Turn the Cycle Selector knob to the desired wash cycle. See "Selecting a cycle and time" later
in this section.
• Push the Start/Pause button to start the washer.
NOTE: The cycle selector knob will NOT rotate as the cycle progresses.
• The cycle Status lights indicate the operation being performed within the cycle.
• When the cycle is complete, all Cycle Status Lights will be Off.
NOTE: To change a cycle selection after the cycle has started, turn the Cycle Control knob
to Off, then select a new cycle.
Stopping/restarting your washer
• To pause the washer at any time, push the Start/Pause button. The Cycle Status lights will
flash while the washer cycle is paused. If left in pause, the cycle will terminate after 2 hours.
• To restart the washer, close the lid (if necessary) and push the Start/Pause button.
• To cancel cycle, turn Cycle Selector knob to Off. Cycle Status lights will turn off.
NOTE: When lid is opened during a cycle, all machine operation will stop. Cycle will
resume when lid is closed.

LOADING SUGGESTIONS

For these suggested full-sized loads, set the Load Size selector to the highest load size setting.
Heavy work clothes
Knits
Mixed load
Permanent Press
Towels
Delicates
Appliances
3 work shirts and 2 pair pants
2 slacks and 2 shirts
1 pair slacks, 2 pillow cases, 2 shirts, and 1 T-shirt
2 double sheets and pillowcases
2 single sheets and 2 pillowcases
6 bath towels, 3 hand towels, and 6 wash clothes
1 camisole, 2 slips, 2 panties, 2 bras, 1 nightie, and 1 half slip
- or -
3 dresses
6 shirts
- or -
- or -
9 bath towels
- or -
71