N821 (Option) - Jayco COVE 2002 Owner's Manual

#
CAUTION: To avoid cuts when replacing the light bulbs, wear gloves.
Replacing the Freezer Light Bulb (Fig. 7-7)
1. Unplug the refrigerator.
2. Wear gloves as protection against possible broken glass.
3. Unsnap the light shield as shown.
4. Unscrew and replace the old bulb with an appliance bulb
of the same wattage.
5. Replace light shield.
6. Remember to plug the refrigerator back in.

N821 (Option)

REFRIGERATOR CARE CHECKLIST
Your refrigerator will give you years of trouble free service if you do these simple checks every three
to six months:
• Keep the food compartment and the freezer clean. See "Defrosting" and "Cleaning".
• Defrost the refrigerator as necessary. See "Defrosting" and "Cleaning".
• Make sure the door seals correctly. See "Door Sealing".
• Be aware of any cooling changes that are not because of weather, loading, or gas control
changes. If changes occur, contact your dealer or service center.
• Make sure the gas supply is propane gas only and not butane or a butane mixture.
• When in propane gas operation, examine the appearance of the flame. See "Gas Flame
Appearance".
• Make sure the air flow in the lower intake vent, through the refrigerator coils and condenser,
and out the upper exhaust vent is not blocked or decreased.
• Make sure the area behind the refrigerator is clear. Do not use the area behind the refrigerator
for storage of any combustible materials, especially gasoline and other flammable vapors and
liquids.
DEFROSTING
The cooling fins of the refrigerator operate at below freezing temperature and will naturally form
frost from humidity, which is always present in the air. The humidity inside the refrigerator
increases:
• With higher outside temperature and humidity.
• With the storage of non-sealed fresh foods or warm foods.
• With the amount of time that the door(s) are open.
• With any air leakage into the refrigerator.
Maintenance/Storage
2
1
Fig. 7-7
89