Dryer; Starting Your Dryer - Jayco COVE 2002 Owner's Manual

Dryer

I
WARNING: Explosion Hazard
• Keep flammable materials and vapors, such as gasoline, away from the
dryer.
• Do not dry anything that has ever had anything flammable on it (even
after washing).
• Failure to follow these instructions can result in death, explosion, or fire.
I
WARNING: Fire Hazard
• No washer can completely remove oil.
• Do not dry anything that has ever had any type of oil on it (including cooking
oils).
• Items containing foam, rubber, or plastic must be dried on a clothesline or by
using an Air Cycle.
• Failure to follow these instructions can result in death or fire.

STARTING YOUR DRYER

Before using your dryer, wipe the dryer drum with a damp cloth to remove dust from storing and
shipping.
• Load clothes into the dryer and close the door.
• Turn the Cycle and Temperature Control knob either way to the desired cycle. Use the Energy
Preferred Automatic Setting (*) to dry most loads (see following table of information).
• Push the start button.
NOTE: Your dryer stops automatically when a cycle ends.
• Stopping and restarting your dryer
You can stop your dryer anytime during a program.
• To stop your dryer: Open the dryer door or turn the Cycle and Temperature Control knob
to OFF.
NOTE: The Cycle and Temperature Control knob should point to an Off area when the
dryer is not in use.
• To restart your dryer: Close the door, select a new cycle and temperature (if desired), and
push the Start button.
END OF CYCLE SIGNAL
The dryer sounds a signal to let you know when the cycle is finished. The signal is not adjustable
and cannot be turned off. The signal is helpful when you are drying permanent press, synthetics, and
other items that should be taken out as soon as the dryer stops.
74 Cove Owner's Manual