Inlet Hoses; Caring For Your Dryer; Cleaning The Lint Screen - Jayco COVE 2002 Owner's Manual

TO USE WASHER AGAIN:
1. Flush water pipes and hoses.
2. Reconnect water inlet hoses.
3. Turn on both water faucets.
4. Plug in washer or reconnect power.
5. Run the washer through a complete cycle with 1 cup (250 ml) of detergent to clean out
antifreeze.
NON-USE OR VACATION CARE:
Operate your washer only when you are at home. If you will be on vacation or not using your washer
for an extended period of time, you should:
1. Unplug the power supply cord or turn off electrical power to the washer.
2. Turn off the water supply to the washer. This helps avoid accidental flooding (due to a water
pressure surge) while you are away.

Inlet Hoses

Replace inlet hoses after 5 years of use to reduce the risk of hose failure. Inspect and replace inlet
hoses if bulges, kninks, cuts, wear, or leaks are found. When replacing your inlet hoses, mark the
date of replacement on the label with a permanent marker.

CARING FOR YOUR DRYER

CLEANING THE LINT SCREEN

Every load cleaning
The lint screen is located inside the dryer drum, on the back wall. Clean it before starting each load
(bold). A screen blocked by lint can increase drying time.
To clean:
1. Open the door and pull the lint screen straight out.
2. Squeeze body of lint screen lightly while puling the cover off.
3. Roll lint off the screen with your fingers. Do not rinse or wash screen to remove lint. Wet
lint is hard to remove.
4. Replace cover on lint screen body. Push the lint screen firmly back into place and close the
door.
IMPORTANT:
• Do not run the dryer with the lint screen loose, damaged, blocked, or missing. Doing so can
cause overheating and damage to both the dryer and fabrics.
• Some towels made of synthetic fibers and natural fibers (polyester and cotton blends) may
shed more lint than other towels, causing your dryer's lint screen to fill up faster. Be sure to
remove lint from the lint screen before and after drying new towels.
96 Cove Owner's Manual