Lp Gas Alarm; Smoke Alarm - Jayco COVE 2002 Owner's Manual

LP GAS ALARM

To keep your alarm in good working order, you must:
• Test the alarm weekly. (See Chapter 4 for "Testing Procedures")
• Check the indicator light on the front of the alarm regularly. Make sure it is green in color .
• Vacuum the dust off of the alarm cover weekly, more frequently in dusty locations, using
the soft brush attachment of your vacuum.
• Clean the alarm cover weekly. Hand wash using a damp cloth, or paper towel. Dry with a
soft cloth.
• DO NOT SPRAY CLEANING AGENTS OR WAXES directly onto the front panel. This
action may damage the sensor, cause an alarm or cause an alarm malfunction.

SMOKE ALARM

1. Test weekly by pushing "test" button. The alarm will sound also test by blowing smoke
into alarm. The alarm will stop after the smoke has cleared out of the alarm
(approximately one minute).
2. Model 4662 has a silence feature. This is incorporated in the test button. When this
feature is present, this button is colored yellow. If an alarm is caused by smoke from
cooking, or other non-hazardous sources, it can be silenced for approximately ten minutes
by depressing the test button once. If, during this time the smoke density increases, the
unit will again go into alarm. After the ten minute period, the detector will resume its
normal sensitivity.
3. Clean or vacuum dust from the unit at least once a year. The unit may alarm during
cleaning.
I
WARNING: DO NOT PAINT. Painting this alarm could result in decreasing its
sensitivity to smoke.
I
WARNING: Test Smoke Alarm operation after trailer has been in storage and at
least once per week during use.
Maintenance/Storage 93