Speaker Configuration - Extron electronics SSP 7.1 User Manual

The Center speaker is set as an individual speaker.
•
Large — Bass management is off.
•
Small — Bass management is on.
•
None — No signal is sent to the output for that channel, effectively removing the
•
speaker from the current configuration.
The Back speaker or speakers can be set as a single speaker or as a pair of speakers,
•
depending on the system configuration.
,
2 Large 2 Small
•
whether the audio output channels for the back speakers are output to the left back
and right back (in 7.1 setups) or to the center back (in 6.1 setups).
The can be set to
Subwoofer
•
be enabled or disabled.
Crossover — The crossover frequency sets the boundary below which the low frequency
•
signals from designated output channels are incorporated into bass management (see
page 16). The crossover frequency is adjustable using
the drop-down menu.
From 40 - 80 Hz, increment and decrement in
•
5 Hz steps
From 80 - 150 Hz, increment and decrement
•
in 10 Hz steps
From 150 - 250 Hz, increment and decrement
•
in 25 Hz steps

Speaker configuration

The speaker configuration is displayed in a graphics box
that is very similar to the graphics box shown in the Input
and Output information bar.
Only the speakers available in the current configuration
are displayed.
If the speakers are set to
Large
by large icons, as shown in figure 32. If the speakers are
set to , they are represented by small icons (fore
Small
example the center speaker in figure 32.
If the speakers are set to
None
the current configuration and are not displayed.
If the back speakers are set to
speakers, are shown (6.1 setups). If the back speakers are set to 2 Large or 2 Small, the LB and
RB speakers, but not the CB speaker, are shown (7.1 setups).
Input and Output information bar
The Input and Output information panel
detail starting on page 25.
, , , or
1 Large 1 Small None
or . These options allow the subwoofer to
Present None
, they are represented
, they are not available in
or , the CB speaker, but not the LB and RB
1 Large 1 Small
is available from all GUI tabs and is described in
SSP 7.1 • Setup and Control Software
— These options determine
Figure 31.
Bass Management
Crossover
Figure 32.
Speaker Configuration
28