Loading A Fabric In The Sleeve Attachment - Ricoh Ri 100 User Manual

Printing on Fabric

Loading a Fabric in the Sleeve Attachment

When printing on the sleeves of a fabric, attach the sleeve at-
tachment to the multi tray and load the sleeves in the sleeve
attachment.
•
If you perform printing with the edges of the fabric still outside of the
table, the fabric or this machine might be damaged. After fixing the
fabric, make sure that it fits within the width of the cassette.
•
When fixing sleeves with tape, stick the tape to the side of the sleeve
attachment. If you wrap the tape onto the bottom of the multi tray,
you may not be able to set the sleeve attachment correctly on the
cassette stand.
•
Tuck the protruding fabric under the front side and the side of the
sleeve attachment. If you only tuck the protruding fabric under the
front side, a height detection error may occur or the table may be
damaged because of the thickness of the fabric.
2
Press the [Power] key, and then turn on the machine.
• Detach the cassette after turning on the machine. If you de-
tach the cassette before turning on the machine, turn it off
first, and then turn it on again.
Make sure that the cas-
sette stand is out of the
machine, and then detach
the cassette.
• If it is not out of the machine,
press the [Tray] key (Cas-
sette key) to eject the cas-
sette.
• Lift up the cassette lightly and pull the cassette to detach it.
20
DSB002