Loading A Fabric In The Multi Tray - Ricoh Ri 100 User Manual

Printing on Fabric

Loading a Fabric in the Multi Tray

When you want to print on fabrics that cannot be loaded on the A4
standard tray or A5 tray, use the multi tray at your own discretion.
•
If you perform printing with the edges of the fabric still outside of the
table, the fabric or this machine might be damaged. After fixing the
fabric, make sure that it fits within the width of the cassette.
•
When setting the fabric in the multi tray, set it in the center of the ta-
ble. Otherwise, the table may tilt and the height of the table may not
be correctly detected, which could deteriorate print quality.
•
When setting multiple pieces of fabric on the multi tray, set the thick-
est fabric in the center of the table. Otherwise, the height of the table
may not be correctly detected, and the garment may misfeed and
cause an error.
•
When you fasten fabric to the table with tape, stick the tape to the
sides of the table so that the tape extends towards the back of the
table. If you wrap the tape onto the bottom of the multi tray, you may
not be able to set the multi-tray correctly on the cassette stand.
Press the [Power] key, and then turn on the machine.
• Detach the cassette after turning on the machine. If you de-
tach the cassette before turning on the machine, turn it off
first, and then turn it on again.
Make sure that the cas-
sette stand is out of the
machine, and then detach
the cassette.
• If it is not out of the machine,
press the [Tray] key (Cassette
key) to eject the cassette.
• Lift up the cassette lightly
and pull the cassette to detach it.
2
DSB002
17