Ricoh Ri 100 User Manual page 35

Error Messages
Cannot use High Temp. /
Power Off On
Cannot use Low Temp. /
Power Off On
Hardware Problem Ethernet
Board
Ink Collector is not set / Set
the Ink Collector Unit
Ink Collector Unit is full /
Replace Ink Collector Unit
Low Ink
Maintenance in process...
Maintenance failed
Open Front Cover / Replace
Ink Crtg
Open Front Cover / Reset
Cartridge
Troubleshooting
The temperature is abnormally high or low. Check
the installation area and relocate the machine. Al-
ternatively, wait until the machine acclimates to the
room temperature.
An error in the Ethernet port (Ethernet board) net-
work function has occurred. Disconnect all cables,
turn the machine off, and then turn it on again.
If the message reappears, contact your sales or
service representative.
The ink collector unit is not installed or is installed
incorrectly. Alternatively, an ink collector unit not
meant for this machine may be installed. Install
the ink collector unit for this machine correctly. The
ink collector unit meant for this machine is labeled
"J089" under its handle.
The ink collector unit is full. Replace the ink collec-
tor unit.
The ink will soon run out. Make sure you have a
new ink cartridge for the color indicated by
The machine is cleaning or flushing its print head.
Wait a moment. You might hear a clicking sound
while the maintenance is in process. This is not a
malfunction.
Head cleaning, head flushing, or other mainte-
nance operations have failed. Run the mainte-
nance again after clearing the error. You can clear
a maintenance error when the machine receives
another print job or the [#Enter] key is pressed.
The ink has run out. Install a new ink cartridge for
the color indicated by
See page 55 "Replacing an Ink Cartridge".
The ink cartridges are not installed or are installed
incorrectly. Alternatively, an ink cartridge not meant
for this machine may be installed. Install the ink
cartridge for this machine correctly.
or .
.
3
35