Loading Tab Stock Into The Multi Bypass Tray (Tray A); Loading Paper On The Multi Bypass Banner Sheet Tray - Ricoh Pro C9500 Operator's Manual

2. Paper Specifications and Adding Paper
• Pull the extender out when loading A4 , 8
(Tray A).
• You can load envelopes into the multi bypass tray (Tray A). Envelopes must be loaded in a specific
orientation. For details, see below.
• page 121 "Envelope Orientation and Recommended Status"
• If multiple sheet feeding occurs, fan sheets thoroughly or load sheets one by one from the multi
bypass tray (Tray A).
• Specify the sizes of paper that are not automatically detected. For details about how to specify
sizes, see page 95 "Specifying the Paper Size That Is Not Automatically Detected". For details
about the sizes that can be detected automatically, see below.
• page 98 "Recommended Paper Sizes and Types"

Loading Tab Stock into the Multi Bypass Tray (Tray A)

When setting tab stock, always use the tab fence. Tabs must be set at the right side of the multi bypass
tray (Tray A).
1. Tab fence
2. Fence

Loading Paper on the Multi Bypass Banner Sheet Tray

When the Multi bypass banner sheet tray is attached to the machine, you can load paper that is 487.8
mm–1260.0 mm (19.2–49.6 inches) long horizontally on the tray (Tray A).
1. Remove the fence.
To remove the fence, slide it to the right while pressing down on the stopper.
90
1
/ × 11
2
1
2 2
M0EBIM2121
or larger sheets in the multi bypass tray