Panasonic KX-WP1050 Operating Instructions Manual page 26

Getting Started
Temporary Confidential
cable connecting the modem to your computer. However, the modem needs to remain
connected to the Internet.
3
Connect the included Ethernet cable to the "WAN" port on the base unit and an
Ethernet (LAN) port on the modem.
4
Connect the existing Ethernet cable to the "LAN" port on the base unit and the Ethernet
(LAN) port on your computer (the same Ethernet (LAN) port you have just unplugged
your modem from in step 2).
5
Plug your modem's power adaptor into an AC outlet.
L Wait for your modem's power light to stop flashing before you go to the next step. (It
may take a few minutes.)
6
Connect the included AC adaptor cord to the power port on the base unit and an AC
outlet.
L When the base unit turns on (The WAN indicator lights in green or amber), the
installation is complete.
Checking for Internet access:
Turn on your computer and open the Web browser to check for Internet access. If you
cannot access the Internet, go through the following.
L For Cable modem users: Turn off the modem for 10 minutes to erase the old
information in the modem. If this still does not work, you may need to register the base
unit with your Internet service provider. Provide them with the WAN MAC registration
number found on the bottom of the base unit.
L For DSL modem users: You may need to set the PPPoE configuration for your Internet
connection type in Initialization Wizard (page 27). Do not unplug the power of the base
unit during the setting. If unplugged, it may take a few minutes or more to reset the
PPPoE connection.
26
For assistance, please visit http://www.panasonic.com/phonehelp