Panasonic KX-WP1050 Operating Instructions Manual page 122

Base Unit Settings
Temporary Confidential
4
Configure the settings under the Packet Filtering Setting heading, then click [Add] to
add the new entry.
L Click [Save] under the Packet Filtering Setting heading to save the edited settings.
Setting
[No.]
[Status/Packet
Filtering]
[Action]
[Direction]
[Source IP
Address]
[Source Port]
[Destination IP
Address]
[Destination Port]
[Protocol]
[Log Output]
L When you delete the selected setting, click [Delete].
5
Click [Restart].
122
For assistance, please visit http://www.panasonic.com/phonehelp
Description
L Select the desired entry number for the packet filtering
setting.
L Select whether the packet filtering feature is enabled or
disabled.
L Select whether to allow or deny IP packets that are being
received.
L Select [LiW] (filtering when sending to WAN) or [WiL]
(filtering when receiving from WAN).
L Enter the packet source IP address to be filtered.
L If you want to set one IP address, enter the IP address only.
L If you want to set a range of IP addresses, enter the network
address (e.g. 192.168.0.0/16).
L If you want to set the KX-WPA102 IP address, enter "local".
L If you want to set all IP addresses, enter "*".
L Enter the packet source port to be filtered.
L If you want to set one port, enter its port number only.
L If you want to set a range of ports, enter the port numbers in
the following way: "2000 – 3000".
L Enter the packet destination IP address to be filtered.
L The entry is the same as the Source IP Address.
L Enter the packet destination port number to be filtered.
L The entry is the same as the Source Port.
L Select the desired protocol used.
L Set whether to display the temporarily saved packet
information on the [Packet Filtering Log] (page 138).