Panasonic fp2/fp2sh User Manual page 316

FP2/FP2SH/FP10SH/FP3 (A: Available, N/A: Not available)
Address
FP2/
FP3 FP2SH
FP10SH
- DT90257
- DT90258
- DT90259
- DT90260
- DT90261
- DT90262
- DT90263
Note) For MEWNET-W system, available PLC type: FP2/FP2SH/FP3/FP10SH
For MEWNET-P system, available PLC type: FP3/FP10SH
11-48
Name
Operation An Operation error program block number
error program is stored (higher byte) here when an
No. (hold) operation error is detected.
(Available Program block number
PLC: FP2SH/ - H1: In the first program block
FP10SH) - H2: In the 2nd program block
Operation The program block number for the latest
error program operation error is stored here each time
No. (non-hold) an operation error is detected.
(Available Program block number
PLC: FP2SH/ - H1: In the first program block
FP10SH) - H2: In the 2nd program block
Break
occurrence The program block number where the
program BRK instruction occurred is stored here.
number Program block number
(Available - H1: In the first program block
PLC: FP2SH/ - H2: In the 2nd program block
FP10SH)
Type of IC memory card is monitored
here as:
- H5: Flash-EEPROM type IC memory
card
Type of IC
- H6: SRAM type IC memory card
memory card
- H506: For FP10SH, flash-
(Available
EEPROM/SRAM mixed type IC memory
PLC: FP2SH/
card
FP10SH)
- H6: No archival information is stored
- H6: No data is written
- Other than above: Erroneous condition
(self-diagnostic error code E56)
Capacity of IC
The capacity of IC memory card is stored
memory card 1
in units of KB. If Flash-EEPROM/SRAM
(Available
mixed type IC memory card is used,
PLC: FP2SH/
SRAM capacity is stored.
FP10SH)
Capacity of IC
memory card 2 If Flash-EEPROM/SRAM mixed type IC
(Available memory card is used, flash-EEPROM
PLC: FP2SH/ capacity is stored in units of KB.
FP10SH)
File register
bank (current
The current value of file register bank is
value)
stored here.
(Available
PLC: FP2SH)
Descriptions
Read- Writ-
ing ing
A N/A