Panasonic fp2/fp2sh User Manual page 290

FP2/FP2SH/FP10SH
Address
F152 (RMRD)/P152
(PRMRD) and F153
R9036 (RMWT)/P153
(PRMWT) instruction
end flag
COM port communica-
R9037
tion error flag
R9038 COM port receive flag
R9039 COM port send flag
R903A Not used
R903B Not used
R903C Not used
R903D Not used
R903E Not used
R903F Not used
Error alarm (0 to 2047)
R9040 Available PLC:
FP2SH/FP10SH
11-22
Name
Monitors if an abnormality has been detected during the
execution of the F152 (RMRD)/P152 (PRMRD) and F153
(RMWT)/P153 (PRMWT) instructions as follows:
- off: No abnormality detected.
- on: An abnormality detected. (access error)
The error code is stored in DT90036.
Turns on when the serial data communication error occurs
using COM port.
Turns off when data is being sent by the F144 (TRNS)
instruction.
Turns on when the end code is received during the serial
data communicating.
Turns on while data is not sent during the serial data
communicating.
Turns off while data is being sent during the serial data
communicating.
-
-
-
-
-
-
Turns on while the error alarm relay (E0 to E2047) acts.
Turns off when the all error alarm relay turns off.
Description