Panasonic fp2/fp2sh User Manual page 154

Installation and Wiring
4.4 Wiring the Connector Type I/O Units
When using cable with pressure connection terminal
The connector converted to a pressure connection terminal using the exclusive cable.
The I/O numbers and corresponding pressure connection terminal pin numbers are the
same as for connector terminals on section 4.4.3.
When using flat cable
There is a cable with a connector on only one end.
When using suitable connector, you can use a commercially available flat cable.
For detailed information
Table of Connector and Terminal
Number or connector pins
Using con- g Housing
nector for f
Contact (for AWG22 and AWG24)
wire-pressed wire-pressed
Semi-cover
terminal terminal
cable
Pressure connection tool
Using termi- g CT-2 con-
nal l nector
terminal terminal
RT-2 relay
terminal
(*Note 2) (*Note 2)
Using cable 1m/3.281ft.
with pres with pres-
sure connec-
2m/6.562ft.
tion terminal
Using flat g Flat cable with a
cable bl connector on one end
Connector only
Notes
1) The connectors for wire-pressed terminal cable (40 pins) are
supplied with the unit.
2) The RT-2 relay terminal cannot be used with PNP collector out-
put type output units (FP2−Y32P, FP2−Y64P, FP2−XY64D2P
and FP2−XY64D7P).
4 − 24
section 4.4.4
DIN rail mounting type
Connector 1m/3.281ft.
terminal terminal
2m/6.562ft.
cable
DIN rail mounting type
Connector 1m/3.281ft.
terminal terminal
2m/6.562ft.
cable
1m/3.281ft.
d
2m/6.562ft.
40 pins
Supplied with the unit pp
Maintenance part number: AFP2801 M i t t b
AXY52000FP
AYC1140
AYT51403
AYT51405
AY231502 for input
AY232502 for output
AY15633
AY15635
AYT58403
AYT58405
AFB8541
AFB8542
AFP2802 (40-pin connectors)
FP2/FP2SH
AFP2801