Remove And Replace A Dap (If A New Dap Is Not Available) - Nortel CS 1000 Manual

224 System maintenance
Replacing a DAP
Step
1
2
3
4
5
6
7
8
9
10

Remove and replace a DAP (if a new DAP is not available)

Replace a failed DAP.
Procedure 131
Replacing a DAP
Step
1
2
Action
Ensure that DAP Manager is running before you begin to replace
a DAP.
Ensure that the DHCP server and the TFTP server are running
in the IP network.
Open the DAP Manager Web interface.
Click Access Points.
Disconnect the DAP you need to replace.
Do not continue this procedure until DAP Manager indicates that
the DAP is not working.
Connect the new DAP.
Wait until you see that the new DAP is running (in the DAP
Manager interface).
Click Edit for the new DAP.
Change the RPN number of the new DAP to the RPN number of
the replaced DAP, and click OK.
After the DAP restarts, it has the RPN of the replaced DAP.
Now the subscriptions that were active in the replaced DAP are
automatically installed in the new DAP. This can take a few
minutes.
Check that the subscriptions of the replaced DAP are on the new
DAP.
After you have verified that the subscription records are placed in
the new DAP, switch the handsets associated with these records
off and on to make them operational again.
Check that you can make phone calls using the new DAP.
Action
Open the DAP Manager Web interface.
Click Access Points.
Nortel Communication Server 1000
SIP DECT Fundamentals
NN43120-123 02.02 30 March 2010
Copyright © 2008-2010 Nortel Networks. All Rights Reserved.
--End--