Configuration On Element Manager - Nortel CS 1000 Manual

124 SIPN configuration
6
Configuration on Element manager
Log on to Unified Communications Management (UCM) of the Call Server.
Navigate to Network > Elements and select an Element Manager link
from the list.
This section contains the following procedures:
•
Procedure 57 "Creating a new customer or modifying information about
an existing customer" (page 125)
•
Procedure 58 "Configuring the Zone" (page 125)
•
Procedure 59 "Adding a D-Channel" (page 126)
•
Procedure 60 "Adding a route" (page 126)
•
Procedure 61 "Adding a trunk" (page 127)
•
Procedure 62 "Configuring network access" (page 128)
•
Procedure 63 "Creating ESN Control Block" (page 128)
•
Procedure 64 "Adding digit manipulation block" (page 129)
•
Procedure 65 "Adding route list block" (page 129)
•
Procedure 66 "Adding location code (for UDP)" (page 130)
•
Procedure 67 "Adding Trunk Steering Code (CDP)" (page 130)
•
Procedure 68 "Configuring the signaling server" (page 130)
•
Procedure 69 "Configuring SIP properties" (page 132)
Creating a new customer
Use Element manager and follow the steps in the next procedure to create
a new customer or modify information about an existing customer.
You must enter the PIN within 16 minutes, otherwise the
subscription mode terminates for that specific extension
number, and you must restart the subscription process from the
beginning.
Enter the name and DN of the SIP DECT system.
The DN appears on the handset display. The status of the
subscription record changes from Enabled to Subscribed.
For more information, see
193).
Nortel Communication Server 1000
SIP DECT Fundamentals
NN43120-123 02.02 30 March 2010
Copyright © 2008-2010 Nortel Networks. All Rights Reserved.
"Subscription management" (page
--End--