Configuration On Element Manager - Nortel CS 1000 User Manual

154 System configuration
6
Configuration on Element manager
To log on to Element manager, open a browser and enter as an HTTP
address the ELAN or TLAN address of the Signaling Server. If you are
logging in for the first time, the call server IP address field is empty. Enter
the ELAN address of the Call Server.
This section describes the following procedures.
•
•
•
•
•
•
•
•
•
•
•
•
•
Copyright © 2008-2009 Nortel Networks
.
Sometimes it is necessary to enter PARK code first. The PARK
code is displayed on the left at the bottom of the Subscriptions
page.
Note: If the PIN is not entered within 16 minutes, the
subscription mode is terminated for that specific extension
number and the subscription process must be started from
the beginning.
Enter the name and DN of the SIP-DECT system.
The DN is displayed on the handset screen. The status of the
configuring subscription record changes from "Enabled" to
"Subscribed".
Note: For more information, see
(page 187).
Procedure 60 "Creating a new customer or modifying information about
an existing customer" (page 155)
Procedure 61 "Configuring the Zone" (page 155)
Procedure 62 "Adding a D-Channel" (page 156)
Procedure 63 "Adding a route" (page 156)
Procedure 64 "Adding a trunk" (page 157)
Procedure 65 "Configuring network access" (page 158)
Procedure 66 "Creating ESN Control Block" (page 159)
Procedure 67 "Adding digit manipulation block" (page 159)
Procedure 68 "Adding route list block" (page 159)
Procedure 69 "Adding location code (for UDP)" (page 160)
Procedure 70 "Adding Trunk Steering Code (CDP)" (page 160)
Procedure 71 "Configuring the signaling server" (page 161)
Procedure 72 "Configuring SIP properties" (page 162)
Nortel Communication Server 1000
SIP DECT Fundamentals
NN43120-123 01.07
6 January 2009
"Subscription management"
--End--