Additional Notes On Configuring Cs1000 For Mwi; Configure Microsoft Exchange Unified Messaging In Cs 1000 Element Manager; Configure A Node In Element Manager For Use With Microsoft Exchange Unified Messaging; Nortel Communication Server 1000 - Nortel 1000 Fundamentals

38 Configuration of Communications Server 1000 with Microsoft Exchange Server 2007 Unified
Messaging
Additional notes on configuring CS1000 for MWI
•
•
•
Configure Microsoft Exchange Unified Messaging in CS 1000
Element Manager
The following sections detail the use of Element Manager in configuring
Microsoft Exchange Unified Messaging services on the CS 1000.
The Edit page of the Element Manager Nodes: Servers, Media Cards
configuration page has a new configuration tab – Microsoft Unified
Messaging. The Microsoft Unified Messaging tab is used to add Microsoft
Exchange Unified Messaging numbers that have been defined for use with
Subscriber Access and Auto Attendant and also to configure MWI DNs
and Dialing Plans. Up to five Subscriber numbers and five Auto Attendant
numbers can be configured. These numbers can be added, modified or
deleted using the functions of the Microsoft Unified Messaging tab.
Configure a Node in Element Manager for use with Microsoft Exchange
Unified Messaging
Access to all parameters for configuration of a node for interaction with
Microsoft Exchange Unified Messaging are found under IP Telephony
Node section of Edit page for Nodes: Servers, Media Cards, as shown in
the following figure:
Communication Server 1000 with Microsoft Exchange Server 2007 Unified Messaging Fundamentals
Copyright © 2008 Nortel Networks
.
The SIP DCH should be configured with MWI for the RCAP value (LD
17).
User telephones should be configured with MWA (Message Waiting
Allowed) Class of Service to receive MWI Lamp notification.
The Node configuration page (in Element Manager) needs to be
configured with information for both the MWI Application DN and the
MWI Dialing Plan. The configured MWI DN and MWI Dialing plan
should be administered as a valid DN on the Call Server to ensure
routing back to the SIP gateway; this is required if the ISDN Facility
Response is to be sent back to the SIP gateway. For more information
on configuring the MWI DN and MWI Dial Plan, see
information for the MWI Application DN" (page 43)
Microsoft Exchange Unified Messaging Dial Plan" (page

Nortel Communication Server 1000

NN43001-122 02.04
24 October 2008
"Configure
and "Configure the
25).