6.2.2
Mounting the modules on a DIN rail
This section describes a procedure for mounting the modules on a DIN rail.
An example of the use of the DIN rail stopper is described in the following procedure. Fix the module according to the
manual of the DIN rail stopper used.
(1) Mounting procedure
1.
Pull down all DIN rail hooks on the back of the
modules.
The levers should be pulled down until you hear them
click.
2.
Hang the upper tabs of the modules on a DIN rail,
and push the modules in position.
3.
Lock the DIN rail hooks to the DIN rail to secure the
modules in position.
Push each hook up until you hear it click.
If the hooks are beyond the reach, use a tool such as a
screw driver.
4.
Loosen the screw on DIN rail stopper.
Hook
Hook
CHAPTER 6 INSTALLATION AND WIRING
6
39