Table of Contents
Advertisement
3.3
Mounting the Modules on a DIN Rail
This section explains the procedure for mounting the modules on a DIN
rail.
POINT
An example of the use of the DIN rail stopper is described in the following
procedure. Fix the module according to the manual of the DIN rail stopper
used.
1. Pull down DIN rail hooks on the back
of the modules until they click.
2. Hang the upper tabs of the modules
on a DIN rail, and push the modules in
position.
Applicable DIN rail model names
(IEC 60715)
• TH35-7.5Fe
• TH35-7.5Al
• TH35-15Fe
3. Lock the DIN rail hooks to the DIN rail
to secure the modules in the position.
Pull the hooks up until they click.
If the hooks are beyond the reach,
use a tool such as a driver.
4. Loosen the screw on DIN rail stopper.
(Use a stopper that is attachable to
the DIN rail.)
38
(To the next page)
Advertisement
Table of Contents
