Siemens SINAMICS G120 Operating Instructions Manual page 93

3. Remove the cable gland plate from the bottom of the inverter.
Figure 4-16
4. Assemble the cable glands with the prepared cables and EMC cable glands for the control
cables.
5. Seal any unused bushings with a rubber sleeve.
6. Secure the bolting plate to the inverter enclosure. Tightening torque 2 Nm.
Make sure that the seal of the bolting plate is not damaged.
7. Connect the mains supply and the motor.
Figure 4-17
8. Close the door of the Power Module.
Make sure that the door seal of the Power Module is not damaged.
Now you have connected both the mains supply and the motor to the FSD ... FSF Power
Module.
Converter with the CU230P-2 Control Units
Operating Instructions, 09/2017, FW V4.7 SP9, A5E34257946B AE
Diameters of the drill holes in the cable gland plates:
20.5 mm Control cables
40.5 mm Mains and motor cables, FSD
50.5 mm Mains and motor cables, FSE
63.5 mm Mains and motor cables, FSF
Bolting plates for PM230 FSD ... FSF Power Modules
Connections for PM230 Power Modules, FSD ... FSF
4.4 Connecting the line supply and motor
Installing
93