Configure The Basic Wireless Settings - NETGEAR WAC730 Reference Manual

ProSAFE Dual-Band Wireless AC Access Point WAC720 WAC730
2. Configure the IPv4 settings as explained in the following table:
Setting
DHCP Client
IP Address
IP Subnet Mask
Default Gateway
Primary DNS Server
Secondary DNS Server
Network Integrity Check
3. Click Apply button.
Your settings are saved.

Configure the Basic Wireless Settings

For proper compliance and compatibility between similar products in your coverage area, you
must configure the 802.11bg/ng/bgn and 802.11a/a-na-ac wireless adapter settings correctly,
including the operating channel and country. You also must configure the basic wireless
Description
By default, the Dynamic Host Configuration Protocol (DHCP) client is enabled.
The wireless access point receives its IP address, subnet mask, and default
gateway settings automatically from the DHCP server on your network when you
connect the wireless access point to your LAN.
Enter the IP address of your wireless access point. The default IP address is
192.168.0.100. To change the address, enter an unused IP address from the
address range used on your LAN, or enable DHCP the server.
Enter the network number portion of an IP address. Unless you are
implementing subnetting, enter 255.255.0.0 as the subnet mask.
Enter the IP address of the ISP gateway to which the wireless access point
connects.
Enter the IP address of the primary and secondary DNS servers.
A DNS server is a host on the Internet that translates Internet names (such as
www.netgear.com) to numeric IP addresses. Typically your ISP transfers the IP
address of one or two DNS servers to your wireless access point during login. If
the ISP does not transfer an address, you must obtain it from the ISP and enter
it manually in this field.
Select this check box to validate that the upstream link is active before allowing
wireless associations. Ensure that the default gateway is configured.
Initial Setup
19