Cli Commands - NETGEAR ProSafe WNDAP350 Reference Manual

ProSafe Dual Band Wireless N Access Point WNDAP350 Reference Manual
To use the CLI from a Console Port:
1. Using the null-modem cable, connect a VT100/ANSI terminal or a workstation to the port
labeled Console.
If you attached a PC, Apple Macintosh, or UNIX workstation, start a secure terminal-
emulation program.
2. Configure the terminal-emulation program to use the following settings:
• Baud rate: 9600 bps
• Data bits: 8
• Parity: none
• Stop bit: 1
• Flow control: none
These settings appear below the connector on the back panel.
3. Press Enter. The screen shown below in
Figure 3-3
4. Enter the login name and password (admin and password are the defaults).
After successful login, the <Access Point Name> prompt should appear. In this example, the
prompt is netgear74F35E.
5. Enter to display the CLI command help.
help

CLI Commands

The CLI commands are listed in
3-4
Figure 3-3
Appendix C, "Command Line
v2.0, April 2013
should appear.
Reference."
Management