Fax Features - Panasonic DP-MB311EU Operating Instructions Manual

10.1.2 Fax features

Feature
TEL/FAX delayed
ring count
Turning the AUTO
ANSWER
Sending report
Automatic journal
report
Manual answer
mode
Default fax
resolution
Duplex print
setting for fax
reception
Code Selection
#212 If you use an extension telephone in TEL/FAX mode, select the desired number
of times the extension telephone rings before the unit answers the call.
M1N "1"
M2N "2" (default)
M3N "3"
M4N "4"
M5N "5"
M6N "6"
M7N "7"
M8N "8"
M9N "9"
Note:
R See page 61 for details.
R The selection may vary depending on the location setting (feature #114 on
page 67).
R If you change the location setting (feature #114 on page 67), the TEL/FAX
delayed ring count will be reset to "2". If necessary, select the desired ring
count again.
#319 This feature is only available when "GERMANY" is selected in feature #114 on
page 67.
M0N "OFF"
M1N "ON" (default)
Note:
R See page 60 for details.
#401 To print a sending report.
M0N "OFF": Sending reports will not be printed.
M1N "ON": A sending report will be printed after every fax transmission.
M2N "ERROR" (default): A sending report will be printed only when fax transmission
fails.
#402 When "ON" is selected, the unit will print a journal report automatically after every
30 new fax transmissions and receptions (page 58).
M0N "OFF"
M1N "ON" (default)
#404 To change the receiving mode in the manual answer setting (page 60).
M1N "TEL" (default)
M2N "TEL/FAX"
#405 To change the default resolution setting for fax.
M1N "STANDARD" (default): For normal-sized characters.
M2N "FINE": For small-sized characters.
M3N "SUPER FINE": For very small-sized characters.
M4N "PHOTO": For photographs, shaded drawings, etc.
Note:
R Using the "FINE", "SUPER FINE" and "PHOTO" settings will increase
transmission time.
#407 To set the duplex print for fax reception.
M0N "OFF" (default)
M1N "LONG EDGE"
M2N "SHORT EDGE"
10. Programmable Features
75