Panasonic DP-MB311EU Operating Instructions Manual page 118

12. Help
12.4.7 Network
Problem
I cannot operate the following
functions.
– PC printing
– Scanning
– Remote Control
– PC FAX
– Device Monitor
– Secure Print
– Proof Print
The unit does not appear in
the [Select a Network Device]
dialogue box when installing
Multi-Function Station.
118
Cause & Solution
R If the LED (Orange) is not illuminated, confirm the LAN cable is connected
to the LAN port of the main board correctly. The cable should be a CAT 5
(Category 5) or higher for 10 Base-T/100 Base-TX, or CAT 5e (Enhanced
Category 5) or higher for 1000 Base-T.
R If the LED (Green) is blinking and you cannot perform the desired
operation, the IP address of the unit may have changed.
To detect the IP address, click [IP Change] in the connection error
message dialogue. The IP address for the unit will be detected.
LED (Orange)
LED (Green)
Note:
R If the IP address cannot be detected, enter it manually (feature #501 on
page 85). The IP address of the computer and the unit must be in the same
local IP address class as shown below. Set the IP address in the range of
the number specified in the class corresponding to your local network
scale.
Class
Class A
Class B
Class C
*1 "xx" should be the same value for the unit and for the computer,
as shown in the following example.
Example: 172.16.0.1 - 172.16.255.254
(The available range of "xx" is 16 - 31)
*2 "xx" should be the same value for the unit and for the computer,
as shown in the following example.
Example: 192.168.0.1 - 192.168.0.254
(The available range of "xx" is 0 - 255)
R Your firewall software is blocking the connection. Disable the firewall
software or change the firewall settings to make the Multi-Function Station
work properly.
R If feature #580 has been set to "OFF", change the setting to "WIRED" or
"WIRELESS". If feature #580 has been set to "WIRELESS", refer to
"12.4.8 Wireless LAN" on page 119.
R Make sure the network is configured correctly. Consult your network
administrator.
R Your firewall software is blocking the connection and the setup program
may not list any units. Consult your network administrator and temporarily
disable the firewall software.
R The unit is connected to another network segment and the setup program
may not list any units. Make sure the network is configured correctly.
Consult your network administrator.
Communication link status indication
– OFF: Communication link down
– ON: Communication link up (Any speed)
Data transmission or reception indication
– Blinking: Transmitting or receiving data
Subnet mask IP address
255.0.0.0 10.0.0.1 -
10.255.255.254
255.255.0.0 172.xx.0.1 -
172.xx.255.254
255.255.255.0 192.168.xx.1 -
192.168.xx.254
*1
*2