Data And Operator Errors, Bytes 0 To 7 - Siemens SIWAREX WT241 Manual

11.25.1

Data and operator errors, bytes 0 to 7

In this area, messages are represented by bits. A set bit means that the corresponding
message is activated. The message bit is set following a data or operator error and
automatically reset approximately 3 seconds later.
Message bits are analyzed by the operator panel message system.
11.25.2 Modbus RTU error code
The error code is displayed here of the error which was triggered last as a result of a
command at the Modbus RTU interface.
11.25.3 Modbus Ethernet error code
The error code is displayed here of the error which was triggered last as a result of a
command at the Modbus Ethernet interface.
11.25.4 SIWATOOL error code
The error code is displayed here of the error which was triggered last as a result of a
command at the SIWATOOL interface.
11.25.5 Error code following commands at digital input
The error code is displayed here of the error which was triggered last as a result of a
command via the digital input.
SIWAREX WT241
Manual, 05/2015, A5E36046748Aa
11.25 DR 32 display of data and operator errors
Communication
163