Dr 17 Control Analog Output - Siemens SIWAREX WT241 Manual

Communication

11.18 DR 17 Control analog output

11.18 DR 17 Control analog output
If data record DR 17 is configured as the source for the analog output (see Analog output
source (Page 130)), specifying a control output sends a corresponding output current at the
analog output.
Procedure
● In data record DR 7, check that "Control by DR17" has been configured as the source for
the analog output
● Check the analog output configuration (see Analog output source (Page 130))
● Enter a value in data record DR 17
● Transfer the data record to the scale
Table 11- 18 Assignment of data record 17
Variable Note
Data record Contains no. of data record
number
Length Data record length information
Application Information about which applica-
tion the data record belongs to
Version Information about current data
identifier record version
Analog out- Value which is to be output (only
put specifica- relevant if source is "External
tion specification", see DR 7)
(Page 146)
Reserve 1 Reserve
Reserve 2 Reserve
11.18.1 Analog output specification
The value to be entered must be between the start value (Page 131) and the end value
(Page 131) of the analog output.
146
Type L Rw
USHORT 2 r
USHORT 2 r
USHORT 2 r
USHORT 2 r
FLOAT 4 rw
SHORT 2 rw
USHORT 2 rw
Default Min. Max.
17 - -
16 - -
104 - -
1 1 65635
0 - -
0 0 -
0 0 -
Manual, 05/2015, A5E36046748A
Register
1588
1589
1590
1591
1592
1594
1595
SIWAREX WT241