Siemens SIWAREX WT241 Manual page 74

Scale parameters and functions of the belt scale
8.10 Menu 2.2 Scale status
Status digital outputs
Status analog output
2.2.3 Scale status 3 of 5
Flow rate < min. flow rate
Flow rate > max. flow rate
Speed < min. speed
Speed < max. speed
Belt load < Min. belt load
Belt load < max. belt load
Zero range
Zero setting active
Automatic zero-tracking
enabled
Totalizers active
Totalized disturbed
Totalizers enabled
Belt is running
> Min. belt load for totaliz-
ing
2.2.4 Scale status 4 of 5
Speed simulation active
74
Current status of digital inputs DQ.0 to DQ.3. A green highlight-
ed flag stands for an activated output.
The actual value of the current (in mA) which is output at the
analog output.
Overview of the status of limits
Set in case minimum flow rate is underrun
Set in case maximum flow rate is exceeded
Set in case minimum speed is underrun
Set in case minimum speed is exceeded
Set in case minimum belt load is underrun
Set in case maximum belt load is exceeded
Set in case belt load is within zero range
Set in case automatic zeroing is active
Set in case automatic zero-tracking is enabled
Set in case totalizers are active
Set in case totalizers are disturbed
Set in case totalizers are unblocked
Signalsthe belt is runnings
Set in case minimum belt load for totalizing is not underrun –
this is a condition for totalizing
Further process values
Set in case simulation mode speed is active
SIWAREX WT241
Manual, 05/2015, A5E36046748A