Table of Contents
Advertisement
1 Safety Instructions
This document contains important information, which should be kept at all times with the instrument during its
operational life. Other users of this instrument should be given these instructions with the instrument. Eventual
updates to this information must be added to the original document. The instrument can only be operated by
trained personnel in accordance with these instructions and local safety regulations.
Acceptable Operation
This instrument is intended only for the measurement of temperature. The instrument is appropriate for
continuous use. The instrument operates reliably in demanding conditions, such as in high environmental
temperatures, as long as the documented technical specifications for all instrument components are adhered to.
Compliance with the operating instructions is necessary to ensure the expected results.
Unacceptable Operation
The instrument should not be used for medical diagnosis.
Replacement Parts and Accessories
Use only original parts and accessories approved by the manufacturer. The use of other products can compromise
the operation safety and functionality of the instrument.
Instrument Disposal
Operating Instructions
The following symbols are used to highlight essential safety information in the operation instructions:
Pay particular attention to the following safety instructions.
ENDURANCE 1R
info@Raytek-Direct.ca
Disposal of old instruments should be handled according to professional and environmental
regulations as electronic waste.
Helpful information regarding the optimal use of the instrument.
Warnings concerning operation to avoid instrument damage and personal injury.
The instrument can be equipped with a Class 2 laser. Class 2 lasers shine only within the visible
spectrum at an intensity of 1 mW. Looking directly into the laser beam can produce a slight,
temporary blinding effect, but does not result in physical injury or damage to the eyes, even when the
beam is magnified by optical aids. At any rate, closing the eye lids is encouraged when eye contact is
made with the laser beam. Pay attention to possible reflections of the laser beam. The laser functions
only to locate and mark surface measurement targets. Do not aim the laser at people or animals.
Use in 110/230 V~ electrical systems can result in electrical hazards and personal injury, if not properly
protected. All instrument parts supplied by electricity must be covered to prevent physical contact and
other hazards at all times.
Safety Instructions
Rev. E1 Sep 2015
7
1.800.868.7495
Advertisement
Table of Contents
