Operation
6.1.1 The Temperature Display (green 7-segment LED type)
The temperature display always shows the current value of the measured target temperature,
including the result of any signal processing (such as Averaging, Peak Hold, Valley Hold). Units of
measure are set in the screen display – Configuration mode – described later in this section.
The Temperature Display has to fulfill two tasks to inform the operator:
•
In normal operation after warm up phase, it displays the current measured object
temperature, including any signal processing like "Averaging Hold", "Peak Hold" or "Valley
Hold". The displayed temperature depends on the preset measurement unit (°C or °F), done
in the "CONFIGURATION MENU" and described hereafter.
In abnormal operation, during warm up phase or in failure case, discovered through the
•
failsafe-circuit, it displays an error code (e.g. ECHH, ECUU, EUUU, EAAA...). Please see
section 11.2 Fail-Safe Operation on page 55.
6.1.2 The Screen / Menu Display
INTERNAL TEMP.
The Screen/Menu Display is the central user interface display, which shows all selected menus, their
submenus and parameters. In dependence of the selected main menu item, it displays the first
submenu item as default. The menu, submenu and entry selection will be done by specific buttons,
described herein afterwards.
6.1.3 The Pointing Device Indicator LED (red)
Indicates the switched-on state of the integrated pointing device LASER, LED or CAMERA.
6.1.4 The Status Indicator LED (green)
Shows a steady green after warm up period to indicate an error free function of the Endurance device.
30
info@Raytek-Direct.ca
23.5 °C
Rev. E1 Sep 2015
ENDURANCE 1R
1.800.868.7495