Table of Contents
Advertisement
7.7 Factory Defaults
To globally reset the unit to its factory default settings, go to the "factory default" menu item under
the configuration screen menu display. The baud rate and communications mode (single device or
multiple devices / multidrop) will not be affected.
ENDURANCE 1R
info@Raytek-Direct.ca
Parameter
Mode (1C / 2C)
Temperature Unit (°C / °F)
Slope
Emissivity
Transmissivity
Average
Peak Hold
Valley Hold
SETPOINT in (°C / °F)
DEADBAND in (°C / °F)
RS485 Communication Mode
MULTIDROP ADDRESS
TERMINAL RESISTOR
ETHERNET DHCP
ETHERNET IP-ADDRESS
ETHERNET NETMASK
ETHERNET GATEWAY ADDR.
ETHERNET PORTNUMBER
WEB SERVER
ANALOG OUTPUT MODE
OUT Lo LIMIT for 4 mA
OUT Hi LIMIT for 20 mA
Serial Output Transmission Mode Burst mode, Default string = UTSI
Relay Output Control
Set Output Current
Lockout Control Panel Access
*
RS485 Modes, like Baud Rate or 2-wire half duplex, are unchanged when the factory defaults are restored
Signal Post Processing Details
As shipped from Factory (Defaults)
2C- mode
C
1.000
1.00
1.00
0.0
0.0
0.0
0.0
2
2-wire half duplex, 38.400 Baud *
000 (single Endurance sensor)
OFF
OFF
192.168.42.132
255.255.255.0
192.168.42.1
6363
OFF
4 – 20mA
Low end of sensor temperature range (e.g. 400.0°C)
High end of sensor temperature range (e.g.3000.0°C)
Controlled by unit, NO function (indicates failsafe alarms)
Controlled by unit, 4-20 mA
Unlocked
Table 2: Factory Defaults
Rev. E1 Sep 2015
39
1.800.868.7495
Advertisement
Table of Contents
