Table of Contents
Advertisement
Operation
6 Operation
Once you have your sensor(s) positioned and connected properly, the system is ready for continuous
operation. Operation is accomplished either through the back panel or through controlling software
via the RS485 or LAN/Ethernet interface. An Endurance software, a MS-Windows based setup and
configuration program is supplied with your sensor. You can also create custom programs using the
communication protocols listed in section 10 Programming Guide.
6.1 Control Panel
The Endurance sensor is equipped with a control panel, which is the manually operated user interface
and consists of two display types, one alarm and one status LED and several setting/controlling
buttons, as shown in Figure 19. The panel is used primarily for setting up the instrument and is
protectively covered over during normal use by the supplied end cap. You can configure sensor
settings with the control panel or remotely with a computer.
The sensor has a remote locking feature that keeps the unit from being accidentally changed from the
control panel (locked by default in multidrop mode). This lockout mode denies access to the submenu
functions of the control panel. Via the RS485, the LAN/Ethernet connection or a specific key command
on the control panel, the Endurance device can be unlocked.
Figure 19: Control Panel
ENDURANCE 1R
29
info@Raytek-Direct.ca
1.800.868.7495
Rev. E1 Sep 2015
Advertisement
Table of Contents
