Polycom SoundStructure C16 Design Manual page 386

Design Guide for the Polycom SoundStructure C16, C12, C8, and SR12
set phone_connect
"Phone Out" 1
get phone_connect
"Phone Out" 0
Command
set phone_dial "Phone
Out" "9,18009322774"
A - 44
val phone_connect
"Phone Out" 1
val phone_connect
"Phone Out" 0
phone_dial Dial The Telephony Interface
Argument
Channel Type
Value Type
Read/Write Mode
Phys Chans
Virt Chans
System Limits
Description
This command dials the specified string of digits on the telephony interface.
This parameter can be used to dial one digit at a time or many digits all at once.
For the PSTN interface, valid digits are '0' through '9', '*', '#', and ',' (delay).
If the telephony interface is not connected (see the phone_connect parameter)
when this parameter is set, the digits will not be dialed. The phone must be
taken off hook by setting phone_connect to 1 before the digits can be dialed.
Examples
Response
val phone_dial "Phone
Out" "9,18009322774"
Takes the phone output channel "Phone Out" offhook.
Note that the phone out virtual channel name must be
used, not the phone input virtual channel name.
Hangs up the phone line associated with the virtual
channel "Phone Out". Note that the phone out virtual
channel name must be used, not the phone input virtual
channel name.
Argument value
Virtual Channel
String
Write-Only
Analog Telephony Output
Mono
Max String Length: 32
Description
Dials the phone line associated with the virtual channel
"Phone Out" with the digit string "9,18009322774". The
phone line must be offhook for the digits to be dialed -
see phone_connect. Note that the phone out virtual
channel name must be used, not the phone input virtual
channel name.