Print Setup - Oki MC573 Advanced Manual

Print Setup

• Print Menu
• Color Menu
• System Configuration Menu
• PCL Setup
• PS Setup
• XPS Setup
• SIDM Setup
• IBM PPR Setup
• EPSON FX Setup
• Private Print Setup
Print Menu
• Print Setup
Item Factory
default
setting
Copies 1
Duplex OFF
Media Check Enable
Override A4 / Letter Yes
Resolution 600dpi
Toner Save Toner Save OFF
Level
Color All
Mono-Print Mode Auto
Description
Sets the number of copies. For local printing, this setting is
invalid except for demo data.
Available range: 1 to 999
Turns the duplex printing function on or off.
[OFF]: simplex printing
[Long Edge Bind]: duplex printing for long-edge binding
[Short Edge Bind]: duplex printing for short-edge binding
Sets whether to check an inconsistency between the page size
and the paper size in the tray.
Set the function that automatically switches paper to print from
A4 to Letter if a tray runs out of A4 paper and Letter paper is
loaded, or from Letter to A4 if a tray runs out of Letter paper.
Sets the resolution.
Sets the amount of toner to be saved.
This setting is enabled when copying, printing, printing
received faxes, and printing from USB Memory.
[All]: Toner Save is applied to all colors including 100% black.
[Except100%Black]: Toner Save is applied to all colors other
than 100% black.
This function is only applied to the print function.
Sets the print mode for black-and-white pages.
Item
Orientation Portrait
Edit Size Cassette size
Trapping OFF
Width / Length 210 mm (8.3
inch) or
216 mm (8.5
inch)
297 mm (11.7
inch) or
279 mm (11
inch)
• Printer Adjust
Item
Manual Timeout 60 seconds
Timeout Injob 40 seconds
Timeout Local 40 seconds
Timeout Network 90 seconds
Print Mode Without Color Toner Alarm
Jam Recovery Enable
Paper Black Setting 0
Paper Color Setting 0
SMR Setting Black 0
Yellow 0
Magenta 0
Cyan 0
- 333 -
9. Operating Management/ Specifications
Factory Description
default
setting
Sets the page orientation.
Sets the size of the printable page area if the size is not
specified with the paper edit size command from a computer.
Set trapping
Sets the width of a custom paper size.
Available range: 64 to 216 mm (2.5 to 8.5 inches)
Sets the length of a custom paper size.
Available range: 90 to 1,321 mm (3.5 to 52.0 inches)
Factory Description
default
setting
Sets for how many seconds the machine waits for paper to be
fed before cancelling a job when using the manual feeder.
Sets for how many seconds the machine waits until pages are
output from when the processing of the received data stops.
Sets how long each port is left opened after a job is complete.
(The network is excluded.)
Sets how long the network port is left opened after a job is
complete.
Sets whether to print the document in black and white or stop
with alarm when a color toner empty error occurs.
Sets whether to print the pages again that are not printed due
to a paper jam after the jam is cleared.
Adjusts finely if the black contrast becomes weak or blots or
lines become conspicuous when printing on plain paper.
If fine blots or lines appear, decrease the value. If the dark part
becomes light, increase the value.
Adjusts finely if the color contrast becomes weak, or blots or
lines become conspicuous when printing on plain paper.
If fine blots or lines appear, decrease the value. If the dark part
becomes light, increase the value.
Corrects variations in print results caused by temperature and
humidity conditions and differences in print density and
frequency. Change the setting if the print quality is uneven.