SiENBE04-925_A
To start 3-D Airflow
1. 3. Press the "SWING button
the "
To cancel 3-D Airflow
2. 4. Press either the "SWING button
COMFORT AIRFLOW operation
•
Notes on flaps and louvers angles
•
When "SWING button" is selected, the flaps swinging range
depends on the operation mode. (See the figure.)
Three-Dimensional (3-D) Airflow
•
Using three-dimensional airflow circulates cold air, which tends
to collected at the bottom of the room, and hot air, which tends
to collect near the ceiling, throughout the room, preventing
areas of cold and hot developing.
ATTENTION
•
Always use a remote control to adjust the angles of the flaps
and louvers. If you attempt to move it forcibly with hand when it
is swinging, the mechanism may be broken.
•
Always use a remote control to adjust the louvers angles. Inside
the air outlet, a fan is rotating at a high speed.
Operation Manual
" and "
" display will light up and the flap and louvers will move in turn.
Check COMFORT AIRFLOW operation in the section of COMFORT AIRFLOW Operation
and "INTELLIGENT EYE Operation"
" and the "SWING button
" or the "SWING button
In DRY mode or
COOL mode
COMFORT AIRFLOW
Upper limit
In HEAT mode
Stop operation
Upper limit
In FAN mode
Upper limit
Operation Manual
":
".
5°
15°
50°
Lower limit
Stop operation
30°
70°
Lower limit
80°
COMFORT AIRFLOW
5°
80°
Lower limit
Stop operation
55